3-Point Carry All for Kubota

This entry is part 6 of 6 in the series Projects

Did a little more work on the carry all “frame”. Glued corner braces in all four corners. Glued and screws retaining feet to the corners and back side. These fit over the existing base of the carry all to keep it from shifting side to side. After the glue had a chance to set up, […]

Close the Barn Door! – 3

This entry is part 5 of 6 in the series Projects

Another door on the “Red Barn” was in need of a little (lot?) bit of attention. It’s really pretty simple. A couple pieces of scrap glued together, then planed them up nice and square. Added another piece “cross grain” so it doesn’t just snap off, glued and screwed it on. Then stuck it on the […]

Close the Barn Door 2!

This entry is part 4 of 6 in the series Projects

Finish the latches on the barn door. Seems to work okay, and it looks much nicer with the old rebar and boards removed now. Some may say “Hey, you put the latch on backwards!” Well, yes I did, for a reason. Hopefully for a good reason. Since there is no way to pull the door […]